Don't forget to order a
tilt base ,
radial plate and
NEW SO-239 connector add-on kit now. See the
DXE-HUS-6BTV-P for a cost-effective kit of the necessary components for a high-performance installation.
The Hustler 6-BTV is a six-band trap vertical antenna that provides an omni directional pattern. The 6-BTV is designed for operation in the 10, 15, 20, 30, 40 and 75 or 80 meter bands. This antenna performs well in restriced space areas. For optimal performance, radial wires should be used.
The Hustler 6-BTV provides electrical selection of bands through the use of optimum Q traps, which are individually and precisely tuned and internally sealed at the factory. The traps are parallel tuned circuits which provide efficient isolation between the vertical sections, permitting multi-band operation. Broadband operation over the entire ham band at very low SWRs is possible in a proper installation.
The Hustler 6-BTV was designed to provide optimum performance from both an electrical and mechanical standpoint. Mechanically, this antenna boasts a heavy duty base and heavy duty aluminum tubing. The mechanical assembly is accomplished with all stainless steel hardware.
The performance provided by the Hustler 6-BTV is better than any other antenna of this type. Broad banding is such that one measurement and setting permits both phone and CW operation. The antenna provides a nominal 52 ohm base impedance when installed and tuned according to the instructions. The radiation efficiency is equivalent to, or greater than, other trap verticals.
- East to assemble and tune
- Band coverage: 10, 15, 20, 30, 40 & 75 or 80 meters (easily tuned to either)
- In deed restriced areas, all BTV models may be disguised as a flag pole. Disguised Flagpole article (720 K pdf)
- The DX Engineering Tilt Base allows the antenna to be easily brought down during non-operating times or for tuning and maintenance.
For the most accurate tuning and best performance, we recommend using the
MFJ-259B antenna analyzer while adjusting lengths and recalibrating traps.
Many DX Engineering accessories for the Hustler BTV antennas are available for a complete, high performing installation - see a complete description in
New Assembly and High Performance Installation Instructions (3.3M pdf). This will answer all your questions:
- Ground, roof or elevated mount?
- Radials or no radials?
- What accessories do I need?
- How about WARC band operation?
- ...and much more!
For an easy, neat and effective way to connect those essential radial wires and the coax to your vertical antenna and for the strongest signal possible use the
DX Engineering Stainless Steel Radial Plate and Accessories.
If you wish to reduce feedline radiation and improve the performance of your Hustler BTV or any vertical antenna, a DX Engineering
Vertical Feedline Current Choke Kit is recommended.
To improve the SWR and operation on 80 meters, you should use the
DXE-VMN-1 Matching Network. A good radial system will usually require this inductance for best impedance matching.
Live in an area that experiences high gusts of wind? Take a look at our
BTV Guying Kits to safe guard your station, work and hard earned money.
Lightning Protection Tech Articles Protect your installation and equipment!
Hustler 6-BTV New Assembly and High Performance Installation Instructions (3.3M pdf)
; "Hustler 6 BTV Antenna, 80-75/40/30/20/15/10m, w/ DXE High Performance Guide")
