DX Engineering BMP-2B Boom to Mast Plates DXE-BMP-2B

DX Engineering BMP-2B Boom to Mast Plates keep your Yagi stable and properly secured on the mast! Fabricated from 0.250 in. thick 6061-T651 aluminum, BMP-2B plates come pre-drilled for DX Engineering Saddle Clamps for greater clamping power without crushing! They're ready to accommodate booms and masts as follows:

-- For mounting a 1.500 in. boom, use (2) DXE-SAD-150A Clamps
-- For mounting a 2.000 in. boom, use (2) DXE-SAD-200B Clamps
-- For mounting a 3.000 in. boom, use (2) DXE-SAD-300B Clamps
-- For mounting to a 1.500 in. mast, use (2) DXE-SAD-150A Clamps
-- For mounting to a 2.000 in. mast, use (2) DXE-SAD-200B Clamps
-- For mounting to a 3.000 in. mast, use (2) DXE-SAD-300B Clamps

Always insist on genuine DX Engineering SAD-series U-Bolt Saddle Clamps for the maximum surface gripping area - they are truly non-slip! Competitors' guillotine-type "muffler clamps" were never intended for this type of application.

But don't stop there! With BMP-2B Boom-to-Mast Plates and DX Engineering Saddle Clamps, now you can build the best mounting systems available. Use these plates for a virtually unlimited number of applications, such as building or mounting HF Yagi beams, VHF and UHF long boom Yagi beams as well as vertical antennas. Use them to build tower side mount brackets, H-frames, truss brackets, mount strut tubes, tower side-arms and create tubing splices, and so many more! Upgrade an existing beam to have the ultimate boom-to-mast connection.

Give your antenna the ultimate stability high atop your tower! Mount your antenna directly to the mast and prevent the boom on your Yagi antenna from twisting on its axis or on the mast with DX Engineering BMP-2B Boom to Mast Plates!

Warranty