MFJ 259D 280 kHz - 230 MHz plus 2200 Meter Antenna SWR Analyzers MFJ-259D

4.25 out of 5 stars ( 19 )

Part Number: MFJ-259D

Not Available

Antenna Analyzer, HF/VHF, Antenna/SWR/RF, LCD, 280 kHz-230 MHz, Dial Tune Knob, UHF Female, SO-239, 12 Vdc, Each
See More Specifications

MFJ 259D 280 kHz - 230 MHz plus 2200 Meter Antenna SWR Analyzers MFJ-259D

MFJ 259D 280 kHz - 230 MHz plus 2200 Meter Antenna SWR Analyzers MFJ-259D

MFJ-259D

4.25 out of 5 stars ( 19 )

Part Number: MFJ-259D

Not Available

Overview

Brand:
MFJ
Manufacturer's Part Number:
MFJ-259D
Part Type:
Product Line:
DXE Part Number:
MFJ-259D
UPC:
650619125900
Antenna Analyzer Frequency Range:
0.10-0.14/0.28-230 MHz
Case Included:
No
RF Connector Type:
UHF female, SO-239
Band Selection Control:
Rotary switch
Frequency Control Style:
Dial
Internal Battery Operation:
Yes
Power Supply:
Ten AA batteries
Batteries Included:
No
External Power Input Voltage:
12 Vdc
Analyzer Width:
4.000 in.
Analyzer Height:
6.750 in.
Analyzer Depth:
2.000 in.
Quantity:
Sold individually.
Notes:
Extra band-switch prevents use of MFJ-259B protective case. Use optional MFJ-29D protective case.

MFJ 259D 280 kHz - 230 MHz plus 2200 Meter Antenna SWR Analyzers

MFJ 259D 280 kHz - 230 MHz plus 2200 Meter Antenna SWR Analyzers are compact, battery-powered RF impedance analyzers. They combine four basic circuits; a 100-140 kHz and 280 kHz to 230 MHz variable frequency oscillator, a frequency counter, a 50 ohm RF-bridge, and an 8-bit micro-controller. These analyzers make a wide variety of useful antenna or impedance measurements, including coaxial cable loss and distance to an open or short. Although primarily designed for analyzing 50 ohm antenna and transmission line systems, MFJ 259D Analyzers also measure RF impedances between a few ohms and several hundred ohms.

They also function as a signal source and frequency counter! Their frequency range of impedance measurement is done with several overlapping bands. The accuracy of the analyzers is enhanced by the use of special microwave zero-bias Schottky detectors with matching compensating diodes. They are compensated to provide the best possible linearity with both high and low impedance loads, making the A/D converter's 0.5 percent resolution the primary limitation.

Unlike the old MFJ's 259B Antenna Analyzers, these new "D" versions have two frequency-range knobs. The new lower-frequency coverage allows analysis of 137 kHz, 472-479 kHz and 160 through 1.25 meter antennas, including MW (AM broadcast) and shortwave frequencies. The extended coverage for the new 630 and 2200 meter bands is a very worthwhile addition!

MFJ 259Ds may be used to test:

*Antennas: SWR, impedance, reactance, resistance, resonant frequency, and bandwidth
* Antenna tuners: SWR, bandwidth, frequency
* Amplifiers: input and output matching networks, chokes, suppressors, traps, and components
* Coaxial transmission lines: SWR, length, velocity factor, approximate Q and loss, resonant frequency, and impedance
* Filters: SWR, attenuation, and frequency range
* Matching or tuning stubs: SWR, approximate Q, resonant frequency, bandwidth, impedance
* Traps: Resonant frequency and approximate Q
* Tunes circuits: Resonant frequency and approximate Q
* Small capacitors: Value and self-resonant frequency

MFJ-259Ds are a complete Ham Radio test station with frequency counter, RF signal generator, SWR/Resistance/Reactance/Coax Analyzer, Capacitance/Inductance Meter and much more. Get one of your own MFJ 259D 280 kHz - 230 MHz Plus 2200 Meter Antenna SWR Analyzers from DX Engineering and be CERTAIN of your antenna system's performance!

Documentation

Instruction Sheets for Part Number MFJ-259D

Technical Articles for Part Number MFJ-259D

 Loading...
 Loading...

Reviews Write a Review

Some parts are not legal for use in California or other states with similar laws / regulations

Modal Header

Call To Order

This is a custom order part. You can order this part by Contacting Us.

CA Warning Icon

Cancer and Reproductive Harm -- www.P65Warnings.ca.gov

Email this page