DX Engineering Product Videos

9/13/2018 - DX Engineering Product Videos

Mark, W8BBQ shows how easy it is to use the DX Engineering Custom Cable Builder

8/21/2018 - DX Engineering Product Videos

Updating the Firmware - Icom IC-7300

DX Engineering's Mark, W8BBQ explains how to update the Icom IC-7300 firmware. This firmware version update is 1.30. For more information on the IC-7300 and other amateur radio products, visit DXEngineering.com....

8/17/2018 - DX Engineering Product Videos

Ray Higgins, W2RE installing Four-Square System using four of the DX Engineering DXE-7580FS-VA-2 vertical antennas in Eastport, Maine.

8/10/2018 - DX Engineering Product Videos

Updating the Firmware - Icom IC-7610

Step by step instructions showing how to update the firmware using a USB thumb drive. For more information on the IC-7610, visit DXEngineering.com....

8/1/2018 - DX Engineering Product Videos

National Weather Center Installs a SkyHawk Tri-Band HF Antenna

The NWC at Oklahoma University in Norman, OK installed a DX Engineering SkyHawk 3x10 Tri-Band antenna in June 2018. It is up at 150 feet and working great. Video submitted by Kim Elmore, N5OP - OU Amateur Radio Club Faculty Advisor....

4/25/2018 - DX Engineering Product Videos

KB8O Uses the NCC-2 on 160M FT8

Jay, KB8O shows how the DX Engineering NCC-2 Receive Antenna Phasing Controller reduces noise. He's testing it on 160 Meters using the FT8 mode....

3/6/2018 - DX Engineering Product Videos

NTE Electronics Heat Shrink Self-Solder Butt Splice Connectors

DX Engineering carries the NTE Low Temp Solder Wire Connectors. All you need is a heat gun to make solder connections between wires. Four sizes for wires ranging from 24 through 10 AWG....

12/6/2017 - DX Engineering Product Videos

Unboxing and Getting on the Air with the IC-7610 at DX Engineering.

Type "IC-7610 SDR Transceiver" into the search box at the top of this page to learn more. ...

9/25/2017 - DX Engineering Product Videos

During a visit to DX Engineering, Will Jourdain, AA4WJ from ICOM America talked about the Icom ID-4100A and the Terminal Mode and Access Point Mode for D-Star.

Type "ID-4100A" into the search box at the top of this page to learn more....