DX Engineering TWIG QRP Monoband Dipole Antenna Kits DXE-TWIG-DIPOLEK
Part Number: DXE-TWIG-DIPOLEK
DX Engineering TWIG QRP Monoband Dipole Antenna Kits
TWIG QRP Dipole Antenna Kit, 40-10M, 25W SSB/10W CW/5W Dig., TWIG 1:1 Choke Balun, Two x 35 ft. 24 AWG Wire, 2 Winders & 4 BongoTies, Kit
See More Specifications
Estimated Ship Date from Ohio: Monday 11/23/2026 Would you rather pick it up?
Overview
DX Engineering TWIG Monoband Dipole Kits
DX Engineering TWIG QRP Monoband Dipole Antenna Kits provide everything needed to build a lightweight, low-power (QRP) standard Dipole antenna using the DXE-TWIG-1-1 QRP Choke Balun. Designed for portable operating, these kits make it easy to assemble an efficient monoband dipole antenna for outdoor activities such as POTA® and SOTA®, as well as other field and portable operations. This antenna kit comes with enough wire to operate on any single band, 40 through 10-meters, depending upon the length of wire cut for both legs of the dipole according to the included instructions. When properly constructed and supported with the center feedpoint at least 15 feet above ground, this antenna is rated for 25 watts SSB, 10 watts CW, and 5 watts digital modes.
At the heart of this dipole antenna kit is the included DXE-TWIG-1-1 choke balun, which features a 1:1 impedance ratio needed for a typical monoband dipole antenna center feedpoint, for the desired 50-ohm impedance required by standard coaxial feedlines. A BNC female connector provides compatibility with recommended coaxial cables and most QRP transceivers. When installed correctly and tuned to the desired operating band, the included 24 AWG PVC-insulated, stranded copper, high-visibility yellow antenna wire works well across the target band without an external antenna tuner. This reduces the amount of gear operators need to carry into the field while allowing for improved operating efficiency.
For best performance, a lightweight coaxial feedline with BNC connectors (sold separately) measuring approximately 25 to 35 feet is recommended. These antennas can be deployed in a variety of configurations, with final wire length varied based on the target band required.
DX Engineering TWIG QRP Monoband Dipole Kits Include:
(1) DXE-TWIG-1-1 QRP Choke Balun
(2) DXE Lightweight Wire Winders
(2) End Insulators
(4) Bongo Ties
(3) Hanging Clips
(2x35ft.) 24 AWG PVC Insulated High-Viz Yellow Antenna Element Wire
(1) Instruction Manual
Specifications
Reviews Write a Review
Some parts are not legal for use in California or other states with similar laws / regulations
Modal Header
Call To Order
This is a custom order part. You can order this part by Contacting Us.