Not Available
Hi-Z Antennas 75 ohm Receive Preamps
DISCONTINUED Preamplifier, Receive, Inline, 75 ohm, 300 kHz - 30 MHz, 13.8 Vdc, Each
See More Specifications
Not available? No problem! We recommend these similar substitute parts:
Overview
Hi-Z Antennas 75 ohm Receive Preamps
Hi-Z Antennas 75 ohm Receive Preamps are in-line devices that were designed to be used as system amplifiers for 160 and 80 meter receive antennas and arrays. Their primary purpose is to provide a precision termination for an antenna array controller. Connected to the output of an array controller, they typically provide a nominal 15 dB of voltage amplification, with a nominal input impedance of 75 ohms when the output port is also terminated in 75 ohms. Alternatively, these preamps are good in the shack, at the receive antenna input of a transceiver or receiver.
Here are the Hi-Z 75 ohm Receive Preamps featured specs:
* Quality G-10 fiberglass circuit board
* F connectors for the RF input and output
* Drives 75 ohm coaxial cables at over +20 dBm
* Preamp is relay bypassed when power is removed
* Operates from 13.8 Vdc at 40 mA
* Stainless stud external power input connection
* Dimensions: Length 4.6 in., Width 2.6 in., Height 1.6 in. (not including the terminals or connectors)
Are you building up a new active receive array? Do you need to amplify the signals from your existing Hi-Z or other receive-only antenna system? If so, then order Hi-Z 75 ohm Receive Preamps right here from DX Engineering, your exclusive Hi-Z Antennas products dealer!
Reviews Write a Review
Some parts are not legal for use in California or other states with similar laws / regulations
Modal Header
Call To Order
This is a custom order part. You can order this part by Contacting Us.