are intended to be placed in line with coaxial cable fed antennas and equipment used for portable operations, including POTA and SOTA activations. The DXE-LPFC-BNC coax wound toroid achieves an amazing common mode impedance (CMI) curve, with an RF choking capability that far exceeds the CMI of 'a-few-beads-on-coax' product that is offered by other suppliers. Actually, these 50-ohm "Low Power" Feedline Chokes can be used in any station that runs less than 250 watts SSB, 100 watts CW or Digital.

DX Engineering Low Power Feedline Chokes features and benefits:

- A unique, lightweight form, with clear heat shrink over the choke*

- Light enough to hang inline at the feedpoint of any portable HF antenna.

- BNC female connectors for easy connection to portable antennas and gear.

- Much higher CMI that other portable, low power chokes, especially across the 40 through 6 meter bands.

- Frequency range of 1.8 through 54MHz.

- RF Power Handling up to 250 watts PEP SSB, 100 watts CW and Digital (at SWR <2:1).

- Bidirectional Input/Output, 50 ohm Impedance, similar to a 1:1 balun with <1.15:1 SWR and minimal insertion loss of 0.2dB at 30MHz

- Recommended for general use to isolate either end of a coaxial cable.

* Not intended for permanent outdoor use unless mounted inside a weatherproof enclosure.

These chokes are ideal for use at any HF transceiver or receiver antenna connection, portable, mobile or base. In most cases, DXE-LPFC-BNC prevents RFI, stops stray RF and noise on the feedline from getting into the receiver that would cover up weak signals, and improves efficiency of the antenna system. For any station, including POTA and SOTA, mobile and base, DX Engineering Low Power Feedline Chokes keep the RF controlled.