Overview

DX Engineering Electronic Protection Components

DX Engineering Electronic Protection Components may be used in a variety of electronics and radio applications. These are wire lead components that can be used on circuit boards or in multi-purpose connection devices. Choose from the components listed for detailed specifications:

DXE-MOV-82VDC-10 Metal Oxide Varistor, Surge Protector, max. 82VDC/50VAC Pack of 10

DXE-GDT-4KV-5 Gas Discharge Tube, Surge Arrestor, 4kV, Pack of 5

DXE-TVS-1500-10 ESD Suppressor, TVS Diode, Bidirectional, 17VDC max., Pack of 10

DXE-CAP-PT1UF-10 Capacitor, Ceramic, 0.1uf, 1kV DC, RF Bypass, Pack of 10

----------------------------------------------------------------------------------------------------------------------------------

This series of protection components are well suited for the DXE-CLTB Control Line Terminal Board that provides a flexible and simplified approach to control line surge protection.

The DXE-CLTB is a small, 3 inch square printed circuit board (PCB) with four ten-wire compression screw terminal blocks that handle from 14 to 26 AWG conductors and up to 10A. The two outer terminal blocks are for input and output of the control wires and the two 45 degree angled ten-wire compression screw terminal blocks are for connecting electronic surge protection components. This provides for the choice of components to install between the control line and ground to provide shunt protection. Metal Oxide Varistor (MOV), Gas Discharge Tube (GDT), EMP Suppressor TVS Diodes, RF Bypass Capacitors and other wire lead components are easily connected between the control lines and ground. For effective protection wherever shunt devices are used, a low impedance ground is critical.

The DXE-CLTB Control Line Terminal Board has four corner grounding screw holes for mounting on metal standoffs to a metal grounding panel inside an enclosure.

DXE-CLTB-M Control Line Terminal Board includes a 10-pack of MOVs.

Reviews Write a Review