Overview

DX Engineering LMR400UF Ultra-Flex Coaxial Cable Assemblies

DX Engineering LMR400UF UltraFlex Coaxial Cable Assemblies handle twice the power at half the loss with the same bending capabilities of smaller diameter coaxial cables. UltraFlex Cable Assemblies are perfect for interconnecting high and low power HF and VHF equipment. Times Microwave LMR® 400UF UltraFlex cable has a stranded bare copper center, foam polyethylene dielectric and a pliable rubber jacket (black thermoplastic elastomer) designed for bending.

DX Engineering LMR400UF UltraFlex DX Series PL-259 Coaxial Cable Assemblies are terminated at each end with our custom-designed, silver-plated brass DX Engineering PL-259 (UHF male) connectors. These next generation PL-259 connectors feature:
-Full diameter, full length soldered center pins that snugly fit even worn SO-239s
-Spacious center pin inside diameter that accepts large conductors and allows generous solder flow
-Deep, double knurled threaded shells for secure finger tightening
These high quality PL-259s have all silver-plated brass shells and bodies with center pins securely mounted in PTFE dielectric for exceptional RF characteristics and power handling.

Our DX Series cable assembly PL-259 center pins are hand soldered by trained assembly techs to assure a proper connection. These special PL-259 cable assemblies also feature machine crimped shields, with 360 degrees of complete mechanical and electrical contact for maximum reliability. Every assembly is continuity checked and evaluated with extremely high voltage, then heat-shrink weather-sealed for ultimate longevity. You will not find this level of cable assembly quality anywhere else!

Terminated with DX Engineering Next Generation PL-259 connectors, these cable assemblies are intended for use to 170 MHz. An exceptionally flexible, low-loss coaxial jumper for high power Amateur or commercial HF or VHF use – order DX Engineering LMR400UF UltraFlex Coaxial Cable Assemblies.