Instruction Sheets for Part Number DXE-UT-80N
DX Engineering Type-N Connector Assembly Tools
Type-N Connector to Cable Assembly Tool, For Two-Piece Solder Type-N Only, Each
See More Specifications
Estimated Ship Date from Ohio: Tomorrow Would you rather pick it up?
Overview
Brand:
Manufacturer's Part Number:
DXE-UT-80N
Part Type:
Product Line:
DXE Part Number:
DXE-UT-80N
Connector Tool Type:
Installation tool
Quantity:
Sold individually.
Notes:
Assembly tool for two-piece Type N connector. US Pat. Pending No. 12/151,441.
DX Engineering Type-N Connector Assembly Tools
DX Engineering Type-N connector assembly tools allow for the threading of the 2-piece Type-N solder-type connector sleeve onto the vinyl jacket of RG-8/U, RG-213/U and other similar sized cables.
It's so easy! First, properly prepare the coaxial cable. Then place the prepared coaxial cable end into the body of the Type-N connector and make sure that all of the strands of the cable's center conductor are inserted into the center pin. Use the patented* DX Engineering Type-N connector assembly tools to thread the Type-N connector body onto the stripped cable end. Tighten the Type-N connector onto the coaxial cable, and when the coaxial cable is fully seated, remove the tools and check to make sure that the coaxial cable is fully seated on the Type-N connector.
If all of the center strands are visible in the small hole of the center pin, then you're ready to solder the connections.
* US Patent # 9,614,341
Documentation
Loading...
Loading...
Some parts are not legal for use in California or other states with similar laws / regulations
Modal Header
Call To Order
This is a custom order part. You can order this part by Contacting Us.
Email this page