Overview

DX Engineering Yaesu Rotator Cable Assemblies

DX Engineering Yaesu Rotator Cable Assemblies are plug and play ready with Yaesu connectors installed, eliminating the trouble and time of soldering wires onto tiny connector pins. These rugged, yet flexible cables are built to last with heavy duty stranded copper 18 AWG 6-conductor covered with our industry leading exclusive direct-bury polyethylene (PE) black jacket that is impervious to water and highly resistant to sunlight UV. The connectors installed mate to the Yaesu rotors and controllers listed. The Yaesu 7-pin plug with screw-on shell (1.030 in. OD) is installed on one end and the 6-pin rectangular keyed connector (0.765 in. max. diagonal) is installed on the other end, each with weather-sealed heat-shrink. Cable assemblies are available in a 10 ft. length for bench testing and for regular runs in 50 ft., 75 ft., 100 ft., 150 ft., 200 ft., 250 ft., and 300 ft. lengths. All cables have six conductors at 18-gauge for complete, full-length compatibility, even though some Yaesu rotators use only 4 or 5 conductors.

DX Engineering Yaesu Rotator Cables are compatible with these Yaesu models:
G-450A
G-450ADC
G-800DXA
G-1000DXA
G-2800DXA
G-5500A*
G-5500DC*
*Azimuth Elevation Rotators require two cables. User will cut off 6-pin connectors and strip leads for the screw terminals on the back of the Azimuth-Elevation controller.


NOTE: Cable may be split, prepped and connected to surge protection (DXE-IS-RCT) at the installation point of the protector, typically at the grounded tower base

Save yourself the hassle of soldering rotator connectors onto cables. Order a spare to have on hand as a replacement for an existing system! DX Engineering Yaesu Rotator Cable Assemblies are ready for your Yaesu rotator system installation.

Reviews Write a Review