AA Logic MCI-102 Mic Control Interfaces allow you to use one microphone on two different radios, even if those radios are from different manufacturers. The MCI-102 also lets you use the same foot switch and amplifier key line on either radio, with no cable juggling, just the flip of a switch. The front panel features four switches: Power, Key Enable, Radio Select and Mic Select, LEDs to indicate status of the MCI-102 at a glance, as well as an RJ-45 and 8-pin foster connection. The rear panel features a pair of 8-pin foster connections, a 1/4-inch mono jack for a foot switch, a 1/8^th inch stereo jack for a boom mic, and RCA connectors for key lines and ALC lines, common to an amplifier, and lines to each of the radios. Power is supplied via the included power adapter.

Additional Feature and Specifications:

• Microphone routing: M1 to Radio 1 or Radio 2 (R1/R2)

• Boom microphone input, 3.5mm TRS (powered via selected tradio)

• Foot switch input, 1/4″ TS

• Switchable external amp keying

• ALC routing or remote antenna switch control

• Compatible with ICOM/Kenwood/Yaesu/Alinco (internal jumper configuration)

• Cross radio compatible (ICOM Mic/Kenwood Radio, etc)

• Full function MIC 1 to Radio 1 Only

• DPDT control switch (SPDT PTT Control, SPDT External R1/R2 Control)

• PTT switchable load (high voltage open collector)

• Single switch changes inputs to selected radio

• KEY enable switch allows operation with or without connected external amplifier