Rig Expert AA-55ZOOM Antenna Analyzer

The RigExpert AA-55 ZOOM Antenna Analyzer is designed for measuring SWR (standing wave ratio), reactance, return loss, cable loss, as well as other parameters of cable and antenna systems in the range of 60 kHz to 55 MHz.

A built-in ZOOM capability makes graphical measurements especially effective.

The following tasks are easily accomplished by using this analyzer:

• Rapid check-out of an antenna
• Tuning an antenna to resonance
• Comparing characteristics of an antenna before and after specific event (rain, hurricane, etc.)
• Making coaxial stubs or measuring their parameters
• Cable testing and fault location, measuring cable loss and characteristic impedance
• Measuring capacitance or inductance of reactive loads

Your lab in the field 

Thanks to its ability to work in conjunction with a netbook or laptop, the RigExpert AA-55ZOOM Antenna Analyzer is truly "your laboratory in the field."

Highlighted Specs and capabilities of the AA-55 ZOOM:
- 60 kHz to 55 MHz
- 1 Hz resolution
- Measurement of 25, 50 75 and 100-ohm impedance systems
– 320×240 color TFT display
– 18-keys waterproof keypad
– Multilingual menus and help screens
– USB connection to a PC

All specifications are listed below.

Download and install the Android application for your smartphone/tablet or AntScope2 for your netbook or laptop to enable these features:

• operate the analyzer remotely
• galvanically isolate the analyzer from the computer device
• see the characteristics of your antenna in more detail
• locate cable faults in TDR mode
• share measurement results through social networks

Here is the link to the RigExpert zip file download which includes drivers and software for use with the AA-55ZOOM and AA-55ZOOM-BT

https://rigexpert.com/files/install/SetupAA55Zoom.zip

RigExpert AA-55 ZOOM Specifications:

Frequency range: 0.06 to 55 MHz

Frequency entry: 1 Hz resolution

Measurement for 25, 50, 75 and 100-Ohm systems

SWR measurement range: 1 to 100 in numerical modes,
1 to 10 in chart modes

SWR display: numerical or analog indicator

R and X range: 0…10000, -10000…10000 in numerical modes,
0…1000, -1000…1000 in chart modes

Display modes:
–    SWR at single or multiple frequencies
–    SWR, return loss, R, X, Z, L, C and phase angle at single frequency
–    SWR chart, 100 points
–    R, X chart, 100 points
–    Smith chart, 100 points
–    Return loss chart, 100 points
–    Cable tools (loss and characteristic impedance)

Optional open-short-load calibration.

Non Volatile memory:
– 10 slots to save measurement results

RF output:
–    Connector type: UHF (SO-239)
–    Output signal shape: square, 0.06 to 55 MHz
–    Output power: +13 dBm (at 50 Ohm load)

Power:
–    Two 1.5V alkaline batteries, type AA
–    Two 1.2V Ni-MH batteries, type AA*
–    Max. 4 hours of continuous measurement, max. 2 days in stand-by mode when fully charged batteries are used
–    When the analyzer is connected to a PC or a DC adapter with USB socket, it takes power from these sources
*Rechargeable batteries are not included with the analyzer.

Interface:
–    320×240 color TFT display
–    6×3 keys on the water-proof keypad
–    Multilingual menus and help screens
–    USB connection to a personal computer

Dimensions: 103 mm x 207 mm x 37 mm (4.1 in x 8.1 in x 1.4 in)

Operating temperature: 0…40 °C (32…104 °F)

Weight: 310 g (10.9 Oz) w/o batteries

Warranty: 2 years

GTIN-13: 4820185420099

RigExpert AA-55 ZOOM is made in Ukraine.

Specifications are subject to change without notice.