DX Engineering Tinned Copper Radial Wire Kits

DX Engineering Tinned Copper Radial Wire Kits include plentiful quantities of biodegradable staples and tinned crimp ring terminals that are easily soldered. Along with spools of the same wire as used by the most successful contest stations and DX enthusiasts for their ground-mounted vertical antennas, these kits will help your antenna system achieve optimal performance. The 16 AWG tinned solid copper wire in these kits provide an extremely cost effective solution for the high-count, full-size ground radial wire systems that are required for top-performing HF vertical antenna installations.

Ground wire radials do not need to be any specific length because the earth detunes them. Fill your ground-mounted vertical space with radials that run out from the antenna feedpoint in all possible directions, as far as they can go, up to about one-quarter wavelength on the lowest frequency. Even radials that are all about one-eighth wavelength long on the lowest frequency band are just fine for multi-band verticals over reasonably conductive soils. Use longer radials on lossy soils with sand and rocks. In most cases, a greater number of short ground radials will provide greater efficiency and stronger signals than is achieved with a few long radials.

DX Engineering Tinned Copper Radial Wire Kits are available in four sizes:
Shorter spool kits, 500 ft. and 1,000 ft., are perfect for the single HF ground-mounted vertical.
Longer spool kits, 2,500 ft. and 5,000 ft., are intended for 2-element Dual Vertical Arrays, 3-element ProStack Arrays, and 4-element Four Square Array Systems.
Each kit has the appropriate number of biodegradable staples and tinned crimp ring terminals.

Why is this wire the absolute best choice for any ground-mounted vertical antenna? Because, DX Engineering Tinned Copper Radial Wire will last much longer in a variety of soil conditions as compared to bare copper, copper coated steel or aluminum wires. Radials deployed with those other wire types actually corrode and degrade rather quickly. Unfortunately, they do so slowly enough that the operator does not easily perceive that degradation in terms of antenna system performance. With Tinned Copper wire, full radial system integrity is maintained for a greater number of years. Depending upon soil type, installations with DXE-TCRW16 will maintain vertical antenna performance for many, many years… and even decades.

NOTE: To prevent accelerated corrosion and the possibility of noise, DO NOT use metal anchor pins (lawn staples) on Tinned Copper Radial Wire. These kits contain only the DXE-STPL-100BD Biodegradable Anchor Pins to hold down bare wire radials. Biodegradable staples allow easy installation of radial wires and will disperse in a couple years, after they are no longer needed, making them site friendly. Biodegradable staples work best in soft ground where they may be pushed or lightly tapped into the ground. Since they are a lacto-resin material they are subject to breaking in rocky or hard soil and are not intended to be hammered.

DX Engineering Tinned Copper Radial Wire kits are the right choice for long lasting top-performance radial systems for your ground-mounted vertical antenna system.
Show Less