Availability
WiMo Antenennen und Electronik Transceivers and Receivers
On Sale
WiMo PicoAPRS and VHF Transceiver with GPS Receiver
WiMo PicoAPRS and VHF Transceiver with GPS Receiver - The world's smallest APRS transceiver gets even better with the introduction of Version 4 of this great little device! As in previous versions, a TNC and a GPS receiver are still included with the addition of a VHF 2-meter handheld transceiver that includes features like a PTT button, microphone, speaker, stored memories, color display and much more! The PicoAPRS V4 is a complete packet radio transceiver with built-in TNC for APRS
( 9 )
$429.99
$343.99
WiMo Transceiver Lifting Handles
WiMo Transceiver Lifting Handles let you lift your expensive transceiver and set it down vertically, without risking damage to the rear panel connectors. Available for a limited number of popular transceivers, these black powder-coated strong metal handles are available in two styles. Angled handles flair out, away from the controls for a better grip. Straight handles allow equipment to be set side-by-side. All versions of the WiMo lifting handles come with mounting screws. The FT-710 version of the lifting handles are angled on the front and have a cutout for the SD Card slot. The Universal version of the lifting handles are straight. Set your transceiver face up on the floor or desktop without worry. Order WiMo Transceiver Lifting Handles from DX Engineering
( 40 )
$41.99
—
$209.99
WiMo TuneRite Tuning Aids
WiMo TuneRite Tuning Aids allow you to make use of the button on your transceiver when using a manual tuner or a manual antenna. The TuneRite simply plugs into the external tuner jack of a compatible radio and allows you to push the button for the automatic tuner to cause the radio to switch to CW or FM and reduce power allowing you to use your manual tuner or adjust your antenna. Once you have achieved your desired match on your antenna system, simply press the tune button again and the radio will return to the mode and power settings it was in before you started tuning. This eases the tuning process and simplifies the steps required to make adjustments with your tuner. Note: When using the TuneRite-KW with a Kenwood TS-480HX, the radio will think that it has a Kenwood tuner connected. Since these tuners do not handle more than 100 watts of power, the TS-480 will reduce it's output power to 100 watts while the TuneRite is connected to the radio. During the tuning process, the power is reduced to 10 watts as usual.
Not Yet Reviewed
$31.99
—
$42.99
WiMo PicoAPRS-Lite APRS Transceiver Module
PicoAPRS-Lite APRS Transceiver Module - the little brother of the popular PicoAPRS. This is a tiny APRS tracker weighing just 7.2 grams*! Even though the PicoAPRS-Lite was developed with balloon flights with APRS payload (Pico balloons and stratosphere balloons) in mind, it can naturally also be used for many more APRS purposes. Thanks to its small measurements of just 27.8 x 66.9 x 6.3mm this tiny tracker can, for example, be installed nearly invisibly in cars. This allows for APRS usage without annoying wiring in the car or too short antenna cables. You can even carry the tracker around in your pocket! An SMA antenna jack is offered separately since its weight of about 2 grams is an unnecessary extra load for the light Pico balloons. This is also the reason why the tracker is being delivered without a case. Special functions of the PicoAPRS-Lite: - Automatic or manual frequency tuning on request. E.g. automatic for worldwide balloon flights. - In areas without APRS coverage and with automatic frequency tuning the ISS APRS frequency is used to be heard even in these situations. - Temperature and air pressure sensor. The values will be sent as an APRS comment in every position. - As an energy source a small solar cell with buffer capacitor can be used, as well as single-use or rechargeable batteries. - Voltage range ca. 3.2 - 5V. - When using a solar cell the PicoARPS-Lite will stay in battery-saving mode use only about 0.1mA until the buffer capacitor has stored enough charge, then sends a beacon and will go back into battery-saving mode to recharge for another beacon if needed. - Even with just one solar cell which supplies the buffer capacitor with just a tiny amount of current it can operate forever in sunshine! Ideal for a world trip with a balloon. - Even when using batteries the energy-saving mode will be used between beacon transmissions to extend the battery's lifetime. - Micro USB port for settings configuration with a terminal software. - Integrated GPS module with balloon mode up to 80km height, ideal for stratosphere balloons. - Transmission power configurable between 0.5 and 1W. - 7-pole lowpass filter to eliminate unwanted spurious emission. Status LED - Firmware updates via USB possible. Future wishes of users and product improvements can be uploaded later. Beware that this device has no voltage regulation! When operating with a solar panel and buffer capacitor the service voltage will usually drop to zero at night. With sunrise the device will be operational soon again. It's important that the tracker can be used with as little power as possible. A voltage regulator would cause a voltage drop which would be inconvenient during sunrise/sundown. To limit the maximum operating voltage a beacon will automatically be transmitted when reaching about 5V in balloon solar mode to use up stored energy. Doing so the maximum operating voltage won't be exceeded even when the idle solar cell provides too much voltage. *1) Weight without antenna jack, case or any energy source. Suggest accessories to be obtained from other sources: - SMA jack for circuit board mounting, upright, with long thread, for single hole fixing. If the device should be in a case and used with a regular antenna. - Lithium polymer battery 3.6V/800mA, as well as compatible connector cable for an external energy source. Beware, the PicoAPRS-Lite has no voltage regulator for batteries! Never charge batteries via USB! - Small USB charger for 4 LiPo batteries max.
( 1 )
$169.99
WiMo PicoAPRS Battery Packs
WiMo PicoAPRS Battery Packs are designed for PicoAPRS V3 and V4, and are suitable for replacing the battery in the PicoAPRS as it ages or secondary batteries for times where your PicoAPRS needs to be able to run without being near a charger.
Not Yet Reviewed
$20.99
WiMo USB Battery Chargers
WiMo USB Battery Chargers allow you to charge a spare battery for the WiMo PicoAPRS. This charger comes with a USB A to USB Micro cable, allowing you to charge the battery anywhere that you have a standard USB charger. Charges the batteries from the PicoAPRS V3 and V4.
Not Yet Reviewed
$30.99