Filters
2 Results Found For "in-line"
EAntenna HF Rotatable Antennas
EAntenna HF Rotatable Antennas include a comprehensive range of mono-band and multi-band Yagi beams and rotatable Delta Loops and Dipoles. Find the band coverage and performance antenna of your dreams right here. For example, the exciting EAntenna 59+ provides great performance on 20, 17, 15, 12 and 10 meters! Check out the specs on this great line of HF directional antennas. DX Engineering offers EAntenna because their attention to manufacturing detail is excellent! Their Yagi, log periodic, and rotatable dipole antennas are built with high-quality stainless steel hardware and aircraft-grade aluminum. As you look through these selections, be aware that advanced, cutting-edge computer modeling and optimization techniques were used to produce every one of the EAntenna premier HF beam antennas and state-of-the-art VHF and UHF Yagi antennas. Their mechanical designs are very robust in every way, as most are rated for at least 100 mph wind survival. To see additional information about each antenna, click on the "More Details" link on the antenna of interest. Then click the Specifications tab to see all of the physical and electrical characteristics of that antenna. EAntenna products are offered exclusively in North America by DX Engineering. Plus, we can ship these great antennas internationally! When you're making plans for a new antenna at your station, look no further for the outstanding solutions by EAntenna, "The Best Choice for Your Antenna System!" NOTE: Manuals are normally supplied bilingual. If your manual lacks an English section, contact DX Engineering for an English version.
( 47 )
$355.99
—
$2,215.99
EAntenna Sloper Antennas
The EAntenna Slopers are shortened with a coil to reduce the antenna length, but behave like quarter-wave sloper antennas. Like any Sloper antenna, it is directional with a low angle for excellent long range DX results. Directivity is away from the supporting metal mast or tower, toward the lower end of the sloper. If a non-metallic vertical support is used for the sloper, an additional vertical wire counterpoise is required. The antenna wire is 2mm (approx. 12 AWG) with UV-resistant insulation for durability. This antenna does not include a balun, but use with a feedline choke, line isolator, or coax bead choke is recommended to achieve the desired results. These antennas are rated for 2 kW CW. The EAntenna EASLP160S achieves a considerable 2:1 SWR bandwidth of 75 kHz. The EAntenna EASLP80S achieves a respectable 2:1 SWR bandwidth of 210 kHz. The assembly and deployment of this antenna is simple. The feedpoint of the antenna is attached to the mast or tower at the minimum height listed below, or higher, if possible, for better results. If supported by a tree, this antenna requires a grounded vertical wire counterpoise, in addition to the coax feedline. With antenna support rope, extend the insulated end to a support a minimum of 10 ft. above the ground. This antenna is preset to the bottom of the band. Adjust to higher frequencies within the band with 5 cm (2 in.) cuts for gradual changes while using an antenna analyzer. In just 5 minutes you can prune the antenna to cover the desired portion of the band. Physical Characteristics of the EAntenna Slopers: * EASLP160 Total Length: 17.7m (58.0 ft.); Minimum Height: 12.7m (41.6 ft.) * EASLP80 Total Length: 11.0m (36.0 ft.); Minimum Height: 8.0m (26.2 ft.)
( 2 )
$122.99
—
$161.99