Availability
InnovAntennas Ferrite Bead Baluns
InnovAntennas Ferrite Bead Baluns are fully assembled and ready to install, to achieve the absolute best performance from an InnovAntennas Yagi or other balanced terminal antennas. In contrast to wound baluns, ferrite bead choke baluns have the advantage of covering a wide frequency range for multiple bands. As required for most Yagi antennas from InnovAntennas with 50 ohm direct feed, ring terminals are installed on one end for the studded feedpoint connection. The other end is terminated in either Type-N or SO-239/UHF Female for the appropriate band coverage and impedance. Heat shrink filled with a UV-resistant adhesive provides a waterproof cover over the ferrite beads on the cable and the connector. Why do I need a Balun on my Yagi? Ferrite Bead Baluns offered by InnovAntennas provide very important functions of a balun, which is not well understood. For proper antenna performance, a ferrite bead balun inhibits common-mode current two important ways; A) it prevents RF flow on the outside the coax shield cable when transmitting, and B) it prevents stray RF noise picked up by the coax cable shield from entering the antenna system and affecting the receiver. What happens on the antenna without a RF choke balun? Several problems can occur. When an unbalanced feedline is connected directly to a balanced antenna with no BALUN in place, common-mode currents will run on the outside of the coaxial cable shield. The Yagi feedpoint is forced out of balance causing a skew and diminished beam antenna pattern and gain. A loss of Front-to-Back ratio (F/B) can occur, as well as detuning that affects antenna frequency, potentially causing increased SWR. In addition to the pattern distorting performance drop, radiation from the antenna feedline can cause interference to home and business electronics. The other very important benefit of using a wideband ferrite bead balun is to reduce received noise in certain situations. While the noise produced by many household products is normally at very low levels, sensitive ham radio receivers can be affected, which can prevents weak signals being heard. RF noise picked up on the coax cable shield will enter the antenna system feedpoint when no ferrite bead choke balun is installed at the feedpoint.
( 3 )
$108.99
—
$119.99
InnovAntennas 144MHz Current Baluns
InnovAntennas 144MHz Current Baluns help to keep common mode currents off your feedline and they ensure that you get the best performance out of your antennas. These InnovAntenna baluns feature a ferrite core covered in a glue filled UV stable heat-shrink. Ring terminals allow for easy connection to the feed point of your Yagi antenna. Why use a balun? When an unbalanced coaxial feedline connects to a balanced antenna, unwanted currents can flow along the coax, distorting your antenna pattern and reducing its Front-to-Back ratio. These currents can also introduce RF interference in your home and even your neighbors' homes. Additionally, the coax can act as an antenna, picking up noise and degrading weak-signal reception. InnovAntennas 144MHz Current Baluns prevent these issues by properly matching your antenna's balanced feedpoint to your unbalanced coax system.
Not Yet Reviewed
$119.99
InnovAntennas OP-DES 50 MHz Yagi Antennas
InnovAntennas OP-DES 50 MHz Yagi Antennas are a relatively new development from InnovAntennas. OP-DES stands for Opposing Phase Driven Element System, in which the ends of the dipole radiator of these antennas is angled backwards towards the reflector, parallel to the boom. This results in opposing phase relationships in the ends of the driven element, providing a very clean directional pattern with few side lobes. The OP-DES Yagi has optimized gain over a wide frequency range, while retaining a good front-to-back ratio. The driven element dipole of an OP-DES antenna has a low impedance of 50 ohms. This eliminates the need for matching elements or a transformer balun. For this reason, the antenna is offered without a balun, but an RF choke balun made of ferrites on coax should be used at the feedpoint terminal studs. With the coaxial cable directly connected to the driven element dipole, well over full legal limit power levels are possible. Like all InnovAntennas Yagis, the OP-DES 50MHz antennas are extremely robustly constructed; the larger model uses truss cables for the boom. All elements of the antenna use high quality aluminum, the clamps and screws are made of stainless steel. The supplied mast clamp is designed for masts up to 2 in. (50mm) diameter. Application Description Monoband Yagis are often used at contest stations, or when you want to use only one band for a certain time, for example to focus on a specific target during sunspot minimum. Another advantage of monoband antennas are the stacking possibilities, i.e. the arrangement of two or more identical antennas properly spaced from each other. InnovAntennas Yagis provide all the necessary technical specifications, so there is no guesswork about the stack spacing. The InnovAntennas OP-DES 50 MHz Yagis are designed through careful numerical optimizations to provide excellent gain with good bandwidth. As a result, a low SWR of 1.1:1 is achieved in the frequency range of 50.0 - 50.6 MHz (6-element) or 50.0 - 51.35 MHz (5-element). The experience of the developer Justin, G0KSC ensure superior operations with these antennas in practice, often supported by a lively exchange between users. TECHNICAL DATA InnovAntennas OP-DES 50 MHz Yagi (Monoband) Antenna Mast Mount: Center Antenna Type Directional Antenna Band 6m Power Handling: 5000 W Polarization: Horizontal Balun Included: No Mast Diameter Max.: 2.00 in. (50mm)
( 2 )
$389.99
—
$529.99
InnovAntennas 10 Element HF Band Optimized Log Periodic Antenna
InnovAntennas 10 Element HF Band Optimized Log Periodic Antenna is a super wideband, high performance beam that covers the frequency range of 14 to 30 MHz. The advantage of this antenna type is the extreme broadband performance with an even gain curve without dips. This makes this antenna suitable not only for amateur radio, but also for commercial services and for demanding SWLs. Through careful calculations and practical optimization, the spacing and lengths of the elements have been chosen to favor the amateur radio bands 20/17/15/12 and 10 meters, creating the Band Optimized Log Periodic Antenna, hence the name "BOLPA". Hundreds of hours optimizing both SWR and performance within the Amateur bands resulted in exceptional mono-band style performance for InnovAntennas BOLPA-10. This antenna provides a uniform gain of approximately 7 dBi over the entire frequency range and a front-to-back ratio over 20 dB on all but 12 meters with an SWR of mostly better than 1.5:1. The boom length of 25.3 ft. (7.7m) is relatively short for an antenna of this type. Since only one 50 ohm feed line is necessary, this broadband antenna is especially well suited for use with modern SDR transceivers that are able to receive on several HF bands simultaneously. This LPDA's double boom is made of 1.75 in. (44 mm) square aluminum, each supporting the alternately arranged elements and provides the support for the bracing in the middle. Both boom tubes serve as feed lines for high power operations on any band with no tuning adjustments necessary. A common mode choke or balun may be used. High quality aircraft grade aluminum, as well as stainless steel parts, means the BOLPA-10 is also designed for adverse weather and high wind speeds of up to 99 mph (160 kph). Some of InnovAntennas HF Log Periodic Dipole Array mechanical design benefits include: * Marine grade stainless steel hardware (wherever possible) * Integrated feed line/boom for maximum efficiency, minimum wind-load * Mill finished for highest levels of accuracy and performance * First-of-kind "Band Optimized" LPDAs by G0KSC InnovAntennas BOLPA-10 technical performance data: * Gain: 6.9 to 7.5 dBi (4.75 to 5.4 dBd) * Gain at 33 ft. (10m) above ground at 14.150 MHz: 11.56 dBi (including ground gain) * Typical F/B: Over 20 dB * Power rating: 5,000 watts (further limited by feedline and connectors) * Feed impedance: 50 ohm, stud connections * Boom length: 25.3 ft. (7.7 m) * Longest element: 42.6 ft. (13 m)
Not Yet Reviewed
$2,190.00
InnovAntennas VertiGO HF Vertical Antennas
InnovAntennas VertiGO HF Vertical Antennas cover multiple bands when fed as a non-resonant radiator using a remote antenna tuner mounted at the base. They can also be fed directly as a monoband vertical and are typically and most easily installed as a ground-mounted vertical, depending on the location and the support. To achieve the matching required by modern transceivers and amplifiers, other shortened vertical radiators use traps or coils but, those components contribute to losses; power lost as heat. InnovAntennas VertiGO Antennas radiate on all bands along their entire length. Radials are required for efficient operation of any HF vertical; 16 or more ground radials are better, where their length isn't critical. A remote tuner installed at the base of the antenna provides maximum efficiency and the best performance on the bands indicated. Higher frequencies will tune but higher angle patterns will limit performance. A ferrite bead choke should be used at the remote tuner on the coaxial cable from the station to prevent it from radiating and collecting RF noise. VertiGO Vertical Antennas from InnovAntennas are available in three different height versions, each with rugged aluminum tubing sections, swaged and slit at the top for the element clamps. Brackets and clamps are included for mounting to a user supplied support pipe.
( 1 )
$399.99
—
$619.99
InnovAntennas 144 MHz OWL Ultra Yagi Antennas
InnovAntennas 144 MHz OWL Ultra Yagi Antennas offer the 2 meter weak-signal enthusiast undeniable low-noise performance with amazing SWR bandwidth, particularly good gain and an excellent front-to-back ratio. Five Optimized Wideband Low-impedance (OWL) Ultra Yagi antennas are available, starting with six element up through ten element models. InnovAntennas' OWL Ultra Yagi beams have been extensively numerically simulated and optimized using special software that includes a 3D simulation of the boom, the insulators, the connector and the cable; an elaborate numerical simulation of these antennas that was inconceivable a decade before. InnovAntenna has achieved the best of what is technically possible for a wideband 2 meter Yagi. The boom of the 144 MHz OWL Ultra Yagi is 1 in. (25mm) square aluminum featuring through-the-boom insulated elements. The adjustable center fed folded dipole has the side opposite the 50 ohm feedpoint connected to the boom, which removes static charge to protect the transceiver. This antenna acts like a band-pass and noise filter outside the 2 meter band, due to rapidly rising impedance. However, the most important feature of OWL Ultra Yagi antenna is optimization for reduced side lobe in the elevation plane, achieving dramatically reduced received noise, even in high ambient noise city locations. The InnovAntennas OWL Ultra Yagis are suitable for all "weak signal modes" on the low end of the 2 meter band due to the optimization for high gain with incredibly low noise for EME, Meteor Scatter, Tropo-DX, Sporadic-E, etc. Despite the robust construction (the antennas can withstand wind speeds of up to 100 mph (160 km/h), the Yagis are still relatively light and thus suitable for smaller masts or for stacking several antennas. The OWL Ultra Yagis do not include a balun, as the coaxial cable connects directly to the loop driven element dipole. The antenna can handle 5 kW, but the recommended choke balun handles a maximum power of approx. 1.0 to 1.5 kW is possible. Exceptionally good SWR is achieved over a wide frequency range. With excellent gain to noise ratios (G/T ratio), the economical InnovAntennas OWL Ultra Yagis are well suited for use in stacked arrays, for EME, satellite or terrestrial operations. Each model listing describes the key benefits of the OWL Ultra Yagi Antennas. Your antenna is a part of your receiver and arguably the most important part of your station. You have spent thousands on radio equipment; make sure you don't short-change your set-up by choosing anything other than an InnovAntennas OWL Ultra Yagi.
Not Yet Reviewed
$274.99
—
$469.99