Selected Filters


Availability


3 Results Found For "Choke"

Part Groups

Results 1 - 3 of 3

EAntenna Sloper Antennas

The EAntenna Slopers are shortened with a coil to reduce the antenna length, but behave like quarter-wave sloper antennas. Like any Sloper antenna, it is directional with a low angle for excellent long range DX results. Directivity is away from the supporting metal mast or tower, toward the lower end of the sloper. If a non-metallic vertical support is used for the sloper, an additional vertical wire counterpoise is required. The antenna wire is 2mm (approx. 12 AWG) with UV-resistant insulation for durability. This antenna does not include a balun, but use with a feedline choke, line isolator, or coax bead choke is recommended to achieve the desired results. These antennas are rated for 2 kW CW. The EAntenna EASLP160S achieves a considerable 2:1 SWR bandwidth of 75 kHz. The EAntenna EASLP80S achieves a respectable 2:1 SWR bandwidth of 210 kHz. The assembly and deployment of this antenna is simple. The feedpoint of the antenna is attached to the mast or tower at the minimum height listed below, or higher, if possible, for better results. If supported by a tree, this antenna requires a grounded vertical wire counterpoise, in addition to the coax feedline. With antenna support rope, extend the insulated end to a support a minimum of 10 ft. above the ground. This antenna is preset to the bottom of the band. Adjust to higher frequencies within the band with 5 cm (2 in.) cuts for gradual changes while using an antenna analyzer. In just 5 minutes you can prune the antenna to cover the desired portion of the band. Physical Characteristics of the EAntenna Slopers: * EASLP160 Total Length: 17.7m (58.0 ft.); Minimum Height: 12.7m (41.6 ft.) * EASLP80 Total Length: 11.0m (36.0 ft.); Minimum Height: 8.0m (26.2 ft.)

5.0 out of 5 stars ( 2 )

$122.99

—

$161.99

Alpha Delta Twin Sloper Antennas

Alpha Delta Twin Sloper Antennas combine the tremendous DX firepower of the quarter wave sloper with the wide bandwidth of the half wave dipole. These model DX-A twin slopers are designed to cover 160, 80 and 40 meters. One leg is 67 ft. long, while the other is 60 ft. long. The sloper antennas install like an inverted-V with ground return accomplished through the tower or down-lead. These antennas utilize stainless steel hardware, 12-gauge solid copper wire, and efficient Alpha Delta "Iso-Res" RF choke coils. Twin sloper antennas are designed for use on an un-guyed metal tower with a beam on top. The beam provides a capacity hat effect and helps to tune the twin slopers. NOTE: It is possible that the introduction of the sloper antennas into a tower system employing multiple guy wires or other attached wire antennas may cause a slight detuning of the sloper antennas. Other installation types will require the use of an outboard wide-range antenna tuner. Time-proven antennas are always good values. Order Alpha Delta Twin Sloper Antennas from DX Engineering and enjoy some vintage wire antenna performance!

5.0 out of 5 stars ( 1 )

$154.99

Alpha Delta Parallel Wire Sloper Antennas

Alpha Delta Parallel Wire Sloper Antennas are designed for limited-space installations that don't allow for the DX-A twin sloper antennas. These antennas have a 50 ohm coax feed and are rated for full legal power. They are designed to use your tower or other antenna support structure. Requiring only 60 ft. of overall length, they provide amazing DX performance at installation heights of only 35 ft. at the high end and 8 ft. at the low end. These antennas are pre-assembled and pre-tuned for an easy installation. DX-B sloper antennas cover 160, 80, 40 and 30 meters. The "top wire" covers 160, 80 and 40 meters. The parallel "underslung" wire covers 30 meters and may be removed or trimmed to 20 meters if desired. Parallel sloper antennas utilize stainless steel hardware, 12-gauge solid copper wire, and efficient Alpha Delta "Iso-Res" RF choke coils. To gain the same broadband performance as the DX-As, the DX-Bs are also designed to be used with a wide-range antenna tuner, so no trimming or tweaking is necessary. Here's an efficient and compact antenna for 160, 80, 40 and 30 or 20 meters. Order your Alpha Delta Parallel Wire Sloper Antennas from DX Engineering!

5.0 out of 5 stars ( 2 )

$159.99

  • 1
  • Page 1 of 1