Selected Filters


Filters


4 Results Found For "Receive Array"

Part Groups

Results 1 - 4 of 4

DX Engineering Receive 8 Circle Array Controllers

DX Engineering RCA8C-1 Receive 8 Circle Array Controllers are the highly sophisticated switch controller relay units from the Eight Circle Array Systems--the receiving systems that use time delay phasing--rather than the conventional narrow-band, frequency-dependent phasing, to provide eight 45 degree spaced directional patterns. The RCA8C time delay phasing is directivity-optimized to produce wider and deeper rear nulls and a narrower main lobe. The result is that noise and undesirable signals are greatly reduced for a superior front-to-rear ratio (F/R). Better control of phase and currents provides a cleaner pattern with the Receive 8 Circle than is available with vertical antenna transmit arrays. DX Engineering Receive 8 Circle Array Controllers are designed to be used with eight identical vertical active or passive vertical elements, symmetrically spaced in a large circle, to provide switching for an 8-direction receiving antenna system. Passive elements will generally provide you with a monoband receiving system. Finally, these systems offer greater reliability in receiving applications. Receive Eight Circle Array Controllers use sealed relays sized for receiving applications with silver contacts to prevent oxidation and contamination. Most transmitting four-square switches use large open-frame relays where the contacts are exposed to the air, which can lead to contamination. Relays with brass contacts can oxidize, leading to poor conductivity. Receive Eight Circle Array controllers feature: * W8JI design * Operation from 100 kHz to 30 MHz * Excellent directivity for better signal-to noise ratio * Switching console provides eight 45 degree spaced directions * Less physical space and maintenance required than phased Beverage antennas * Low current DC powered control console allows system operation without AC power mains The optional DX Engineering Eight Circle Receive Short Element Active Vertical Antenna Package, DXE-RSEAV-8, offers excellent receiving performance from 100 kHz to 30 MHz, while using only a 8.5 ft. (2.6m) aluminum vertical antenna elements. A unique design makes the Receive Eight Circle Array System vastly superior to traditional active vertical antennas in both strong signal handling and feedline decoupling. This results in significantly better weak signal reception due to lower spurious signal interference and reduced noise. DX Engineering RCA8C Receive 8 Circle Array Controllers are the foundation of your Eight Circle Array!

Not Yet Reviewed

$499.99

DX Engineering Receive Four Square Array Controllers

The patented DXE-RFS-3 DX Engineering Receive Four Square Array Controllers are the heart of a sophisticated receiving system that uses time delay phasing rather than the conventional narrow-band, frequency-dependent phasing systems. The time delay phasing is directivity-optimized to produce wider and deeper rear nulls and a narrower main lobe. The result is that noise and undesirable signals are greatly reduced for a superior front-to-rear ratio (F/R). Better control of phase and currents provides a cleaner pattern than those found on available transmit four square arrays. The RFS-3 DX Engineering Receive Four-Square Array Controllers are the switch relay units that are optimized to use the DX Engineering's Active Vertical Antenna Package DXE-ARAV4-4P of four active verticals. These products together offer great F/R response over octaves of bandwidth. DX Engineering's Active Receive Antenna System offers excellent receiving performance from 100 kHz to 30 MHz, while using only a 8.5 ft. antenna element. A unique design makes it vastly superior to traditional active antennas in both strong signal handling and feedline decoupling. This results in significantly better weak signal reception due to lower spurious signal interference and reduced noise. Finally, these systems offer greater reliability in receiving applications. The RFS-3s use sealed relays sized for receiving applications with silver contacts to prevent oxidation and contamination. Most transmitting four-square switches use large, open-frame relays where the contacts are exposed to air, which can lead to contamination. Relays with brass contacts can oxidize, leading to poor conductivity. Advantages of the RFS-3 Receive Four-Square Antenna Systems over other small or medium-size receiving arrays include: * Reduced susceptibility to high angle signals compared to EWE, Flag, Pennant, and K9AY antennas * Excellent directivity in a small space for better signal-to-noise ratio * Switchable in four 90 degree spaced directions * Directivity over a very wide frequency range using DX Engineering DXE-ARAV4-4P active elements * Less physical space required than a Beverage antenna, and active elements need only a minimal ground system * Enhanced relay contact reliability

Not Yet Reviewed

$375.99

DX Engineering Receive Short Element Active Vertical Antennas

DX Engineering Receive Short Element Active Vertical Antennas (the RSEAV Antennas) offer excellent low noise radio frequency reception from 40 kHz to 30 MHz. Better receiving performance than full-size transmit antennas and other active makes the DXE-RSEAV-1 the best choice on the market for VLF through HF reception, including long-distance AM broadcast, Medium Wave and Shortwave (SWL), and new low-frequency Amateur bands, DXing, contesting, and everyday HF operations. Click on a listed product title and Scroll Down to see additional important information. A complete product description appears below the Specifications Overview. Instruction manual links appear in the Documentation section. The sleek and stealthy DXE-RSEAV-1 includes a high-quality three-section 8.5 ft. (2.6m) aluminum tubing whip, insulated mounting plate and the completely new DXE-AVA-3 Active Matching Unit. Its state-of-the-art broadband operational amplifier design works as a high-impedance buffer between the short antenna element and RG6U 75-ohm coax. When installed in the appropriate location, RSEAV antennas provide significantly better weak signal reception than other active receive antennas and full-size transmit-capable antennas, with substantially reduced noise and lower spurious signal interference. Receive Short Element Active Vertical Antennas are intended to be mounted on a ground rod at ground level in a clear area away from all metal, towers and other antennas. They are sold individually (DXE-RSEAV-1), or with a bias tee (DXE-RSEAV-1FVI) and DXE-RSEAV-1 Receive Short Element Active Verticals set a new standard for "Active Receive Vertical Antennas" replacing legacy DXE-ARAV-3, ARAV-2, ARAV-1 and AL-24 versions. Use multiple DXE-RSEAV-1 for all 4 and 8 element DX Engineering Receive Arrays – all 3, 4 and 8 element Hi-Z Antennas Arrays – and 2 element receive arrays with DXE-NCC-2 and NCC-1 Variable Phasing Controllers. The DXE-RSEAV-1 is designed to be a very low-gain, low-noise antenna for greatly improved signal-to-noise performance over a very wide range of frequencies. In a proper single or multi-element array installation, this Receive Vertical antenna will attenuate high-angle skywave signals, which is the goal for a low band DXing receive antenna. Low-angle, long-range DX signals are easier to copy with a good radio and DX Engineering Receive Short Element Active Vertical Antennas. Please Note: To achieve the expected reception pattern, multi-element phased arrays depend upon identical gain and phase response from each element. Every individual element amplifier, its grounding, and even its feedline characteristics and length, must be identical to the others in the array. Therefore, when unrepairable failures occur, it is essential to replace or upgrade all the elements in the array with identical, fully compatible DXE-RSEAV-1 antennas or DXE-AVA-3 units.

4.75 out of 5 stars ( 4 )

$349.98

—

$499.98

DX Engineering Aluminum Receive Element Kits

DX Engineering Aluminum Receive Element Kits provide the parts to make short antennas that are used in receive arrays with special antenna amplifiers. Mounts, clamps, tubing sections and a special insulator are included.

4.5 out of 5 stars ( 2 )

$309.99

  • 1
  • Page 1 of 1