Availability
7 Results Found For "Receive Array"
DX Engineering Receive 8 Circle Array Controllers
DX Engineering RCA8C-1 Receive 8 Circle Array Controllers are the highly sophisticated switch controller relay units from the Eight Circle Array Systems--the receiving systems that use time delay phasing--rather than the conventional narrow-band, frequency-dependent phasing, to provide eight 45 degree spaced directional patterns. The RCA8C time delay phasing is directivity-optimized to produce wider and deeper rear nulls and a narrower main lobe. The result is that noise and undesirable signals are greatly reduced for a superior front-to-rear ratio (F/R). Better control of phase and currents provides a cleaner pattern with the Receive 8 Circle than is available with vertical antenna transmit arrays. DX Engineering Receive 8 Circle Array Controllers are designed to be used with eight identical vertical active or passive vertical elements, symmetrically spaced in a large circle, to provide switching for an 8-direction receiving antenna system. Passive elements will generally provide you with a monoband receiving system. Finally, these systems offer greater reliability in receiving applications. Receive Eight Circle Array Controllers use sealed relays sized for receiving applications with silver contacts to prevent oxidation and contamination. Most transmitting four-square switches use large open-frame relays where the contacts are exposed to the air, which can lead to contamination. Relays with brass contacts can oxidize, leading to poor conductivity. Receive Eight Circle Array controllers feature: * W8JI design * Operation from 100 kHz to 30 MHz * Excellent directivity for better signal-to noise ratio * Switching console provides eight 45 degree spaced directions * Less physical space and maintenance required than phased Beverage antennas * Low current DC powered control console allows system operation without AC power mains The optional DX Engineering Eight Circle Receive Short Element Active Vertical Antenna Package, DXE-RSEAV-8, offers excellent receiving performance from 100 kHz to 30 MHz, while using only a 8.5 ft. (2.6m) aluminum vertical antenna elements. A unique design makes the Receive Eight Circle Array System vastly superior to traditional active vertical antennas in both strong signal handling and feedline decoupling. This results in significantly better weak signal reception due to lower spurious signal interference and reduced noise. DX Engineering RCA8C Receive 8 Circle Array Controllers are the foundation of your Eight Circle Array!
Not Yet Reviewed
$499.99
DX Engineering Receive Four Square Array Controllers
The patented DXE-RFS-3 DX Engineering Receive Four Square Array Controllers are the heart of a sophisticated receiving system that uses time delay phasing rather than the conventional narrow-band, frequency-dependent phasing systems. The time delay phasing is directivity-optimized to produce wider and deeper rear nulls and a narrower main lobe. The result is that noise and undesirable signals are greatly reduced for a superior front-to-rear ratio (F/R). Better control of phase and currents provides a cleaner pattern than those found on available transmit four square arrays. The RFS-3 DX Engineering Receive Four-Square Array Controllers are the switch relay units that are optimized to use the DX Engineering's Active Vertical Antenna Package DXE-ARAV4-4P of four active verticals. These products together offer great F/R response over octaves of bandwidth. DX Engineering's Active Receive Antenna System offers excellent receiving performance from 100 kHz to 30 MHz, while using only a 8.5 ft. antenna element. A unique design makes it vastly superior to traditional active antennas in both strong signal handling and feedline decoupling. This results in significantly better weak signal reception due to lower spurious signal interference and reduced noise. Finally, these systems offer greater reliability in receiving applications. The RFS-3s use sealed relays sized for receiving applications with silver contacts to prevent oxidation and contamination. Most transmitting four-square switches use large, open-frame relays where the contacts are exposed to air, which can lead to contamination. Relays with brass contacts can oxidize, leading to poor conductivity. Advantages of the RFS-3 Receive Four-Square Antenna Systems over other small or medium-size receiving arrays include: * Reduced susceptibility to high angle signals compared to EWE, Flag, Pennant, and K9AY antennas * Excellent directivity in a small space for better signal-to-noise ratio * Switchable in four 90 degree spaced directions * Directivity over a very wide frequency range using DX Engineering DXE-ARAV4-4P active elements * Less physical space required than a Beverage antenna, and active elements need only a minimal ground system * Enhanced relay contact reliability
Not Yet Reviewed
$375.99
DX Engineering Receive Short Element Active Vertical Antennas
DX Engineering Receive Short Element Active Vertical Antennas (the RSEAV Antennas) offer excellent low noise radio frequency reception from 40 kHz to 30 MHz. Better receiving performance than full-size transmit antennas and other active makes the DXE-RSEAV-1 the best choice on the market for VLF through HF reception, including long-distance AM broadcast, Medium Wave and Shortwave (SWL), and new low-frequency Amateur bands, DXing, contesting, and everyday HF operations. Click on a listed product title and Scroll Down to see additional important information. A complete product description appears below the Specifications Overview. Instruction manual links appear in the Documentation section. The sleek and stealthy DXE-RSEAV-1 includes a high-quality three-section 8.5 ft. (2.6m) aluminum tubing whip, insulated mounting plate and the completely new DXE-AVA-3 Active Matching Unit. Its state-of-the-art broadband operational amplifier design works as a high-impedance buffer between the short antenna element and RG6U 75-ohm coax. When installed in the appropriate location, RSEAV antennas provide significantly better weak signal reception than other active receive antennas and full-size transmit-capable antennas, with substantially reduced noise and lower spurious signal interference. Receive Short Element Active Vertical Antennas are intended to be mounted on a ground rod at ground level in a clear area away from all metal, towers and other antennas. They are sold individually (DXE-RSEAV-1), or with a bias tee (DXE-RSEAV-1FVI) and DXE-RSEAV-1 Receive Short Element Active Verticals set a new standard for "Active Receive Vertical Antennas" replacing legacy DXE-ARAV-3, ARAV-2, ARAV-1 and AL-24 versions. Use multiple DXE-RSEAV-1 for all 4 and 8 element DX Engineering Receive Arrays – all 3, 4 and 8 element Hi-Z Antennas Arrays – and 2 element receive arrays with DXE-NCC-2 and NCC-1 Variable Phasing Controllers. The DXE-RSEAV-1 is designed to be a very low-gain, low-noise antenna for greatly improved signal-to-noise performance over a very wide range of frequencies. In a proper single or multi-element array installation, this Receive Vertical antenna will attenuate high-angle skywave signals, which is the goal for a low band DXing receive antenna. Low-angle, long-range DX signals are easier to copy with a good radio and DX Engineering Receive Short Element Active Vertical Antennas. Please Note: To achieve the expected reception pattern, multi-element phased arrays depend upon identical gain and phase response from each element. Every individual element amplifier, its grounding, and even its feedline characteristics and length, must be identical to the others in the array. Therefore, when unrepairable failures occur, it is essential to replace or upgrade all the elements in the array with identical, fully compatible DXE-RSEAV-1 antennas or DXE-AVA-3 units.
( 4 )
$349.98
—
$499.98
DX Engineering Aluminum Receive Element Kits
DX Engineering Aluminum Receive Element Kits provide the parts to make short antennas that are used in receive arrays with special antenna amplifiers. Mounts, clamps, tubing sections and a special insulator are included.
( 2 )
$309.99
InnovAntennas 162 MHz AIS LFA Yagis
InnovAntennas 162 MHz AIS LFA Yagis are vertically polarized Loop Fed Array (LFA) beam antennas designed specifically for 161.5 – 162.5 MHz range, featuring simplified installation with integral rear-mount mast brackets. Three models are offered, each performance optimized with extensive computer modeling. High quality materials are used in manufacturing, ensuring durability and high reliability. LFA Yagis inherently receive less ambient noise and are virtually impervious to the detuning effects of rain and ice that render non-loop antennas unusable. Adverse weather conditions and wind speeds of over 124 mph (200 km/h) are no problem for LFA Yagis. They feature a 50-ohm impedance, low-loss type N female connector. LFA antennas handle a maximum transmitter power of 5 kW. AIS is the maritime Automatic Identification System, a radio-based transponder system that automatically tracks and identifies ships at sea by broadcasting their position, speed, course, and other data. Its purpose is to prevent collisions, assist in search and rescue operations, and help vessel traffic services (VTS) monitor traffic. InnovAntennas 162 MHz AIS LFA Yagis are specially designed for professional use at coastal radio stations, for use with AIS repeaters and for suppliers of AIS systems. Of course, they are also ideal for anyone who would like to enter the exciting and fascinating world of AIS reception or take their existing equipment to the next level. Due to their frequency coverage, InnovAntennas 162 MHZ AIS LFA Yagis are also ideal for long range directional reception of the National Weather Service (NWS) NOAA Weather Radio transmitters broadcasting on 162.400 through 162.550 MHz.
Not Yet Reviewed
$305.99
—
$421.99
InnovAntennas 144 MHz OWL Ultra Yagi Antennas
InnovAntennas 144 MHz OWL Ultra Yagi Antennas offer the 2 meter weak-signal enthusiast undeniable low-noise performance with amazing SWR bandwidth, particularly good gain and an excellent front-to-back ratio. Five Optimized Wideband Low-impedance (OWL) Ultra Yagi antennas are available, starting with six element up through ten element models. InnovAntennas' OWL Ultra Yagi beams have been extensively numerically simulated and optimized using special software that includes a 3D simulation of the boom, the insulators, the connector and the cable; an elaborate numerical simulation of these antennas that was inconceivable a decade before. InnovAntenna has achieved the best of what is technically possible for a wideband 2 meter Yagi. The boom of the 144 MHz OWL Ultra Yagi is 1 in. (25mm) square aluminum featuring through-the-boom insulated elements. The adjustable center fed folded dipole has the side opposite the 50 ohm feedpoint connected to the boom, which removes static charge to protect the transceiver. This antenna acts like a band-pass and noise filter outside the 2 meter band, due to rapidly rising impedance. However, the most important feature of OWL Ultra Yagi antenna is optimization for reduced side lobe in the elevation plane, achieving dramatically reduced received noise, even in high ambient noise city locations. The InnovAntennas OWL Ultra Yagis are suitable for all "weak signal modes" on the low end of the 2 meter band due to the optimization for high gain with incredibly low noise for EME, Meteor Scatter, Tropo-DX, Sporadic-E, etc. Despite the robust construction (the antennas can withstand wind speeds of up to 100 mph (160 km/h), the Yagis are still relatively light and thus suitable for smaller masts or for stacking several antennas. The OWL Ultra Yagis do not include a balun, as the coaxial cable connects directly to the loop driven element dipole. The antenna can handle 5 kW, but the recommended choke balun handles a maximum power of approx. 1.0 to 1.5 kW is possible. Exceptionally good SWR is achieved over a wide frequency range. With excellent gain to noise ratios (G/T ratio), the economical InnovAntennas OWL Ultra Yagis are well suited for use in stacked arrays, for EME, satellite or terrestrial operations. Each model listing describes the key benefits of the OWL Ultra Yagi Antennas. Your antenna is a part of your receiver and arguably the most important part of your station. You have spent thousands on radio equipment; make sure you don't short-change your set-up by choosing anything other than an InnovAntennas OWL Ultra Yagi.
Not Yet Reviewed
$274.99
—
$469.99
EAntenna VU-LFA23 Dualband Antenna
The EAntenna VU-LFA23 Dualband Antenna is the first of its kind. Traditional cross-polarized Yagi antennas are normally offset 90 degrees. However, EAntenna's VU-LFA23 antenna is offset 45 degrees to reduce cross-polarization attenuation. That results in attenuation levels equal to or below 3dB! This antenna also works with independent feeds to optimize incoming signals. General specifications: * Receive CW, SSB, and FM signals without having to change polarity * Hand-built from high-quality T5 6061/6082 aluminum and stainless steel hardware * Accepts masts up to 2.05 in. (52mm) * Square booms increase lateral load handling and resist wind loading Increase your reception across both bands with one antenna---with EAntenna's VU-LFA23 Dualband Antenna from DX Engineering!
( 1 )
$449.99