Availability
Power Dividers, Duplexers and Triplexers
Comet Duplexers
If you are in need of splitting off your HF, VHF, or UHF signals, then Comet Duplexers are what you are looking for. Sometimes referred to as combiners or splitters, these duplexers are basically band-pass filters, simultaneously passing RF in both directions through the common connector, while the band-pass filters provide a high degree of isolation between ports. Additional information: * TX and RX from two radios at the same time into a dual-band antenna. * Combine a dual-band radio with separate outputs into a dual-band antenna. * Separate a single connector duplexed radio into separate antenna systems. * Allow a single coax run into two antennas at the top of the tower, and two radios at the bottom by using a duplexer at both ends of the coax run, avoiding additional coaxial cost and weight. Just imagine the utility of these devices for splitting or combining signals- and adding convenience and cost savings. Order Comet Duplexers from DX Engineering!
( 60 )
$63.49
—
$99.95
Diamond Antenna Triplexers
Diamond Antenna Triplexers are used to split or combine HF, VHF, and UHF signals. These triplexers may be used for combining three transceivers or transceiver connectors with different band ranges onto one coax feed line. Diamond triplexers feature a high-quality aluminum case with a black finish.
( 25 )
$89.99
—
$93.99
Diamond Antenna Duplexers
Diamond Antenna Duplexers are just what you need when splitting HF, VHF, or UHF signals. These duplexers may be used for combining two transceivers into one coax feed line. They are ideal for connecting HF/VHF radios, such ICOM IC-706 and IC-7000 series, and Yaesu FT-857 series, with two antenna ports, to a single feedline multi-band antenna, like the Diamond V7A. Diamond Antenna Duplexers eliminate the need to use an antenna switch and are made with a high-quality aluminum case with a black finish.
( 24 )
$54.99
—
$78.99
WiMo Phase Lines
WiMo Phase Lines are band-specific phasing cable assemblies, either 2 meter or 70 cm, used on the respective WiMo X-Quad Antennas or other cross-polarized Yagi. They combine the vertical and horizontal elements into either Right-Hand or Left-Hand Circular Polarization, dependent upon beam driven element position. Each cable set comes with two male Type-N connector cables, one for each polarization element, combined into one female Type-N connector for the main 50 ohm coaxial feedline to the station. WiMo Phase Lines are used in non-switchable systems.
( 2 )
$99.99
Diamond Antenna Phasing Harnesses
Diamond Antenna Phasing Harnesses provide 2-port phased power division. They are designed for stacking two 2-meter or two 70-cm beams. When you connect your feed line to the SO-239 (UHF female) center, it then provides two outgoing cables terminated in PL-259 connectors. The power division will then feed two Yagis in phase. Diamond Antenna Phasing Harnesses are manufactured using the highest quality materials and have securely attached weatherproof connectors. If you are installing a two-Yagi array, consider one of these handy Diamond Antenna Phasing Harnesses from DX Engineering.
( 3 )
$74.99
Comet Triplexers
Are you in need of splitting off your HF, VHF, or UHF signals, then Comet triplexers are what you are looking for. Sometimes referred to as combiners or splitters, these triplexers are basically band-pass filters, simultaneously passing RF in both directions through the common connector, while the band-pass filters provide a high degree of isolation between ports. Additional information: * TX and RX from three radios at the same time into a single triband antenna. * Combine a triband radio with separate outputs into a single triband antenna. * Allow a single coax run into three antennas at the top of the tower, and three radios at the bottom, by using a triplexer at both ends of the coax run, avoiding cost and weight.
( 17 )
$86.49
—
$95.95