Availability
Balun, UNUN and Choke Replacement Parts
DX Engineering Balun Wiring Kits
DX Engineering Balun Wiring Kits are just the right parts for permanently connecting a DX Engineering Maxi-Core® 20 Balun or a legacy Comtek balun to practically any beam, Yagi, Log Periodic or rotatable dipole with stud terminals on its driven element. This wiring kit is not a bracket. This is 8 AWG tinned solid copper wire, 2 ft., and an assortment of tinned solder ring terminals to electrically connect a #10 or 1/4 inch terminal stud balun to either size two stud balanced feedpoint on antennas of several types. Wire a balun to an antenna feedpoint with the DX Engineering Balun Wiring Kits. DX Engineering Balun Wiring Kits include: - Two feet, 8-Gauge Tinned Solid-Copper Bus Wire - Four each, Ring terminal, solder, for #10 stud - Four each, Ring terminal, solder, for 1/4 in. stud - Two each, Star washers, 1/4 in. - Two each, Nyloc hex nuts. 1/4 in. for 1/4-20 balun studs Instructions for installation: 1. Determine the separated routing of the minimal wire length needed for each balun terminal to antenna terminal connection with drip loops (see 2.), no greater than 12 inches each, from the securely mounted balun to antenna feedpoint. Wires must be separated by 1/2 to 1 inch from antenna metal parts and each other. 2. Include enough wire length for a small drip loop, a downward "U" shape in the wire, to prevent rain water from running straight down into either connection. This drip loop also provides wire strain and vibration relief. 3. Cut the tinned copper wire in half and trim excess to make the two wire lengths, preferably identical. 4. Select the terminals that match the balun and the antenna feedpoint. 5. Solder the tinned ring terminals onto the tinned wire. 6. Install each completed wire assembly with the appropriate size Nyloc nut and star washer along with the hardware supplied with the balun. Attach the other end with hardware supplied with the antenna Use an open end wrench on the balun stud mount nut when tightening Nyloc nuts, and then the wing nuts, to prevent stud rotation and possible internal damage to the balun. NOTE: This 8 AWG tinned copper wire fits into the supplied ring terminals even though both the #10 and the 1/4 in. ring terminal terminals are marked 12-10 (AWG). Soldering these ring terminals onto this wire is required for a permanent connection. Only crimping will produce an insufficient connection. These balun wiring kits may be used on many manufacturers' stud terminal baluns.
Not Yet Reviewed
$12.99
DX Engineering Replacement Ceramic Insulators
DX Engineering replacement ceramic insulators are designed for use with DX Engineering baluns. They are manufactured from quality materials and include one gasket for installation. These through-panel ceramic replacement insulators have a diameter of 1.250 in. and are 0.813 in. tall without the metal hardware (not included). They are also very suitable for homebrew projects and as replacements in special applications such as vintage transmitters or trans-matches. For the best in porcelain insulators, DX Engineering Replacement Ceramic Insulators are the ones to use!
Not Yet Reviewed
$23.99