Availability
Mast Rotator and Bearing Mounts
WiMo GPF-60 Rotator Platforms
WiMo GPF-60 Rotator Platforms are hot-dipped galvanized, sturdy platforms designed for rotators and thrust bearings for rotating masts up to 2.36 in. (60mm) diameter. The fixed mast clamp size range is 1.97 - 2.76 in. (50 to 70mm ) in diameter. The distance from the center of the mast to the end of the platform is approximately 10.83 in. (275mm). The distance from the center of the mast to the center of the mounting position (center of rotor/bearing) is approximately 7.68 in. (195mm). This platform is also designed to accommodate the Yaesu GS-065 Mast Bearing, also available from DX Engineering. Notes: * The Yaesu GS-050 Mast Bearing will NOT fit this mount! * Hy-Gain HAM-IV Rotators have a control cable pigtail on the bottom of the rotator, these rotators must be mounted to the platform using spacers to accommodate the cable. As an alternative, a hole may be drilled into the platform to pass the cable through.
( 2 )
$129.99
Carlson Model 25 Tower Lifts
Carlson Model 25 Tower Lifts are designed for use with Rohn® 25G and Amerite® 25 towers and is a precision-engineered mechanical elevator system that eliminates the need to repeatedly climb sectional lattice towers to perform needed servicing. The initial release, Model 25, works on ROHN® 25G and Amerite® 25 towers up to 60-feet tall. The Carlson Tower Lift can be installed together with new tower installations and retrofitted onto existing towers. The Lift secures the tower-top equipment – antenna(s), mast, rotator, thrust bearing – into a sturdy Carriage that is mechanically raised and lowered on the tower from ground level with an integrated winch-and-pulley system. The Lift enables the antenna and equipment to be lowered to a comfortable working height to safely and easily perform basic antenna equipment service, maintenance and replacement. The Lift then raises the Carriage and equipment back to the top of the tower.
Not Yet Reviewed
$1,499.00