Control Your Turbo with a PRODRAG Booster Controller and Boost Solenoids

Turbocharged engines need a way to control boost pressure. PRODRAG offers two ways to keep boost from going all willy-nilly.

Injector Boost Controller
The PRODRAG Injector Boost Controller is a fast, accurate way to control boost. It uses FID 2000cc injectors. One directs airflow to the top port of the wastegate to open it and reduce boost. The other connects to the bottom port, closing it and increasing boost. This gives you a greater range of control over the minimum and maximum boost levels compared to a spring setup. The controller also holds the boost at the level you dial in as you go down the track—no boost drift here.

The Injector Boost Controller can also be used for standard manifold-referenced boost control as well as C02 and compressed air setups. It has a compact billet aluminum block assembly with an 1/8-inch NPT inlet and dual 1/8-inch NPT outlet ports Two injectors, two injector plug/pin kits, and mounting hardware are included.

Boost Control Solenoids
PRODRAG Boost Control Solenoids regulate the amount of boost pressure in a turbocharged engine. The controllers can be adjusted from 0 to 120 PSI so you can set the amount of boost that reaches the wastegate actuator. PRODRAG Boost Control Solenoids are available in three- and four-port versions and can be used with most engine management systems and boost controllers. Two-way Weatherpack female connector, two Weatherpack pins, and two wire seals are included.

Summit Racing also carries these PRODRAG products:
• Pressure Sensors
• MAP Sensors
• Pro Series Battery Disconnect Switch