Overview

DX Engineering Project Fiberglass

DX Engineering Project Fiberglass is NON-TELESCOPING tubing which is intended to be used as independent parts, or as stock to be cut for parts. Use it for whatever your imagination can devise: cut it into pieces for coil forms, shelf legs, side arms, and so on. The sky is the limit for the number of uses when there is no requirement for telescoping or wall thickness consistency.

DX Engineering Project Fiberglass is limited-availability, non-telescopic fiberglass tubing, sold only in a variety of non-nesting sizes and only as eight foot lengths. An oversize shipping charge will apply. These tubes have a nominal and variable wall thickness of approximately 0.120 inch. Their variable wall thickness makes their openings non-concentric at any point along their length. Therefore, even though two tubes may actually fit or slide together for part of the way, they may get stuck together if you force them. If two tubes do slide together, the next two tubes of the same size may not. This is our definition of non-telescopic tubing.

NOTICE - DX Engineering Project Fiberglass:
1. IS SOLD AS-IS
2. MAY NOT BE RETURNED FOR ANY REASON
3. IS NON-TELESCOPING, EVEN THOUGH IT MAY OR MAY NOT HAVE SLITS IN ONE END
4. CANNOT BE EXPECTED TO BE USED TO MAKE A MAST OR TELESCOPING SUPPORT
5. CANNOT BE EXPECTED TO ASSEMBLE TELESCOPICALLY, NEITHER TEMPORARILY OR PERMANENTLY

DX Engineering Project Fiberglass is non-telescoping tubing. Buy it, as-is, only while limited quantities are available for your non-telescoping fiberglass tubing projects!

Reviews Write a Review