Instruction Sheets for Part Number YSU-M-70
Technical Articles for Part Number YSU-M-70
Yaesu M-70 Desktop Microphones
Desk Microphone, Enhanced Audio Quality, Built-in Low-cut Filter, Compatible w/all Yaesu HF Xcvrs, 8-pin Round and 8-pin Modular Supported, Each
See More Specifications
Estimated Ship Date from Ohio: Today Would you rather pick it up?
Overview
Brand:
Manufacturer's Part Number:
M-70
Part Type:
Product Line:
DXE Part Number:
YSU-M-70
Microphone Type:
Desk/Amateur/Studio
Microphone Element:
Single
Microphone Element Type:
Electret Condenser
Microphone Connector Type:
8-pin round and 8-pin modular
Push-To-Talk Switch:
Yes
Microphone Windscreen Included:
Yes
Microphone Clip Included:
Yes
Radio Connector Cable Included:
Yes
Microphone Base Included:
Yes
Quantity:
Sold individually.
Notes:
Must Use YSU-ABB19X001 Power Supply Kit (sold separately) with the following Yaesu transceivers: FT-1000D/FT-990/890/840/747
Yaesu M-70 Desktop Microphones
Yaesu M-70 Desktop Microphones blend classic design with 21st Century features for a stylish, self-contained and affordable cardioid desk mic for your Yaesu transceiver operating pleasure. The M-70 utilizes a directional condenser microphone element which has precisely tuned frequency response to obtain clear and crisp audio quality. Along with its built-in preamplifier, the M-70 uses three Air-Cylinder tubes, similar to the Reference Microphone M-1, to provide a solid and smooth extended operation.
The M-70 has a simple one-touch PTT key lock button placed just above the PTT key for those long rag chews. This mic preamp features an isolation transformer integrated into the circuit board to enhance audio quality. Also, a built-in Low-Cut filter allows shaping of the low frequency response with a roll-off at 340Hz, -6dB/octave. An ON/ OFF sliding switch is located on the bottom of the microphone.
The M-70 is compatible with all modern Yaesu HF transceivers. Both types of 8-pin mating connectors are on the rear of the M-70 base. By swapping the orientation of coiled cord with opposite connectors at each end, it connects to Yaesu radios equipped with either an 8-pin round or an 8-pin modular mic connector.
* Note: A YSU-ABB19X001 Power Supply Kit (sold separately) is REQUIRED When connecting the M-70 Desktop Microphone to the following legacy Yaesu transceivers:
* FT-1000/D
* FT-990
* FT-890
* FT-840
* FT-747
Order original equipment Yaesu M-70 Desktop Microphones for your Yaesu transceivers from DX Engineering.
Documentation
Loading...
Loading...
Reviews Write a Review
Some parts are not legal for use in California or other states with similar laws / regulations
Modal Header
Call To Order
This is a custom order part. You can order this part by Contacting Us.
Email this page