DX Engineering 1500-Watt Dry Dummy Loads DXE-DL1500U have an attractive, lightweight slotted black aluminum chassis, which provides secure and efficient mounting, RF shielding and air cooling for the large internal resistor. The DL1500U load resistor is nearly three times larger than the resistor in a similar popular dummy load, but this model achieves its performance specifications and will provide years of dependable service.

The DL1500U should be used instead of an antenna, as a stable 50-ohm non-inductive load to a transceiver, transmitter, or RF amplifier on HF and 50MHz:

• Whenever tuning or testing RF equipment for power output or signal quality

• To prevent interference with other stations

• To make audio adjustments on a transceiver while listening on a separate receiver

• To find initial settings on each band segment for variable components on antenna tuners

DXE-DL1500U Dry Dummy Load Specifications:

• Frequency Range: 0 to 54MHz

• RF Connector: SO-239 (UHF Female) Impedance: 50 ohms, nominal

• Power Handling (approx..): 100 watts for 10 minutes; 1.5 kW for 10 seconds

• SWR: <1.1:1 up to 30MHz (<1.06 typical); <1.25:1 up to 54 MHz (<1.17 typical)

• Dimensions, (WHD): 4 x 3-5/16 x 11-5/8 inches, not including connector

DXE-DL1500U-H Dry Dummy Load Specifications:

• Frequency Range: 0 to 30MHz

• RF Connector: SO-239 (UHF Female) Impedance: 50 ohms, nominal

• Power Handling (approx..): 100 watts for 10 minutes; 1.5 kW for 10 seconds

• SWR: <1.1:1 up to 30MHz (<1.06 typical); <1.25:1 up to 54 MHz (<1.17 typical)

• Dimensions, (WHD): 4 x 3-5/16 x 11-5/8 inches, not including connector

Our tradition of building high quality equipment continues. Built to advance the radio art, the DX Engineering DL1500U Dry Dummy Load will provide many years of reliable service.