Momobeam RFC-DU 5kW RF Choke Baluns
Current Choke, 50-Ohm, 7-54MHz, 5kW PEP/1250W Digital, Coax/Ferrite Beads, 17.72in. Length, SO-239 to 2 Wires, M6 Ring Terminals, Each
See More Specifications
Estimated Ship Date from Ohio: Today Would you rather pick it up?
Overview
Momobeam RFC-DU 5kW RF Choke Baluns
Momobeam RFC‑DU 5kW RF Choke Baluns provide an excellent balance of currents and ensure a proper transition between balanced resonant antenna systems (with low SWR)—such as dipoles and Yagi antennas—and unbalanced coaxial feedlines.
These RF Chokes are highly effective at suppressing common mode current from flowing along the exterior of coaxial feedlines, a condition that can cause several issues, including:
- Increased noise levels
- Inaccurate SWR meter readings
- Interference affecting electronic devices within our shack or near the antenna system
See the "Recommended Parts" section for genuine Momobeam Choke/Balun Mounting Brackets, available for compatible square and round Momobeam antenna booms.
Additional Features and Specifications:
RF Choke Type: Current Balun
Frequency Range: 7-50MHz
Power Rating: 5kW PEP* 1250W Digital Modes
Materials: Coaxial cable insulated with Teflon, and surrounded by ferrite beads
Enclosure Type: PVC
Ratio: 1:1, 50-Ohm
Termination Type: SO-239 with PTFE / Two 1.97-inch (5cm) wires to be soldered to M6 Ring terminals
Common Mode Rejection: Up to 20dB
Insertion Loss: <1dB
Length: 17.72in. (45cm)
Weight: 0.77lbs.(0.35kg)
Important: *Digital modes such as FT8 and similar, whose duty cycle is very stressful, we recommend using a power not exceeding 25% of the applicable power of the RF Choke!
A higher applied power could cause irreversible damage!
Specifications
Some parts are not legal for use in California or other states with similar laws / regulations
Modal Header
Call To Order
This is a custom order part. You can order this part by Contacting Us.